Questions & Answers

2014 Honda Accord EVO one ALL doors unlock on single unlock command

0 votes
(Revised) Updaed s/n to correct number number

Just installed an EVO one this afternoon and after completion I am having troubles with the door locks.

It seems all doors unlock, the car starts, then all doors lock again. But now when I go to get in the car I hit unlock once on My remote and all 4 doors unlock instead of the drivers door only. In Todays World this is a security concern for My Wife and I as this is Her car.

Note; I found You can disconnect the wires for the door locks and the EVO one can actually control the locks thru CAN. I tried leaving the door lock/ unlock wires disconected but the doors will unlock/ car start/ then relock, only problem once the engine is running the remote will no longer unlock the doors at all.

I also tried turning off the unlock doors settings in the EVO and to my surprise this car will start without unlocking the doors as well. But the same issue remains the Fortin keeps unlocking all 4 doors regardless of the B1 option being turned on for drivers door only. I have tried different firmware versions with mixed results.

 

I
posté Jan 15, 2017 dans la catégorie Honda par Brian Kerscher (180 points)
modifié Jan 16, 2017 par Brian Kerscher

1 Réponse

0 votes
Looking at the service here: http://fortin.ca/en/support/002B02143870/

This module still has 4.18 in it.

I would suggest updating to the newest version then try and re enable option B1.
répondu Jan 16, 2017 par derek g (339,570 points)
Ah was just a type you made on the service number I see.

If B1 does not work for priority unlocking then this measn the codes we send when the car is running is for all doors not just driver door.

At this time that is normal operation of the unit.
Thanks again Derek for You reply. I have acess to a CAN anylizer program if that helps for any future development work that may be done on this vehicle.

BK
...