3 x lock press on OEM FOB no activity on EVO-VWT1 or Engine start

Question

I just installed (Fortin EVO-RS Audi / VW Plug & Play Remote Starter × 1) EVO-VWT1 according to guide# 32421.  Went through all the steps as outlined in the guide.  Now when I press lock 3 x on OEM key car lock gets activated multiple times but the car does not start and no LED's blink on the module ether, as if it is not registering any signal from the OEM key.   During the setup I used Flash Link Updater chose recommended options, then programmed the module from uploaded DCryptor. 

Answer 1

What is the S/N to the module?

Comments

no, click view other firmwares and re select 64.06 and flash it into the unit.

---

Is the Warning - QR code module required, something to worry about?

---

No, your module is fine.

---

So I reprogrammed the module as you indicated now when I press lock 3x the following LED sequence happens:

Blue LED blink x 3 (when pressing)

on 3rd blick red LED comes on and blue blinks rapidly x2

red LED goes out and red and orage turn on

then both turn off

red comes on and blue blinks twice

No lights on the dash come on

---

At this point I would suggest calling support when you are at the vehicle with access to the module and a flash link updater

1-877-336-7797.