Questions & Answers

I am needing more detailed information/instructions on the wiring diagrams.

0 votes
I'm installing a remote start on a 2006 Buick Lucerne and I used a token for the vehicle wiring specs and it doesn't have all the information needed to make the install. This is not right, because if you going to charge people for vehicle wiring information it should be 90 to 100% correct and all there. The vehicle wiring guide for the 2006 Buick Lucerne doesn't even have the starter wire information. I also bought two Fortin INT-SL-PL by-pass module and there are no information on how to install it and what vehicle it could be used on. Overall, I truly like utilizing your products because I have installed your bypass modules on several cars in the past that yielded successful results. I would be grateful if you are able to rectify this situation so that I can continue being a loyal customer.
asked Mar 1, 2018 in Buick by ranth4@yahoo.com (210 points)

1 Answer

+1 vote
 
Best answer
Looking at the website here: http://fortin.ca/en/vehicles/buick/lucerne/2006-standard-key/ INT-SL+ is not listed as a supported module for your vehicle, Which explains why you cannot find the installation guide for it as it does not exist. For that vehicle you would want either evo-all or evo-one.

 

In regards to the starter wire not being shown... Their is a very simple answer for that,  this vehicle does not use a starter wire at the ignition switch. It uses logic to crank the vehicle, when ign and acc are powered and acc drops the vehicles computer cranks the engine.
answered Mar 1, 2018 by derek g (324,940 points)
selected Mar 1, 2018 by Robert T
...