Questions & Answers

evo-all not programming 2011 Nissan Rogue

+1 vote
I can get the bypass to step 4 but once I try step 6 no red led. I double and triple checked all connections. I tried another bypass and no luck. What am I missing? Is there another way to program the unit?
asked Nov 30, 2013 in Nissan by NPM (140 points)

1 Answer

0 votes

Im assuming this is the model with an Intelligent key?

What firmware is on the EVO? What is the service number?


  • If it's an intelligent key, make sure to remove the valet key from the FOB and place the FOB far from the car.

 

You want to try this:

Reset the module using these steps:

  1. Hold down programming button while plugging in datalink connector.
  2. Let go of button when LED is RED.
  3. Push and hold button again until all three LEDs start to alternate.
  4. Disconnect unit, she is now reset.

 

Before programming the unit with key bypass, try programming only the Can-Bus first. It will help pin point where the problem is coming from.

  1. Hold down programming button while plugging in datalink connector.
  2. Let go of button when LED is BLUE.
  3. Plug in remaing connectors.
  4. Turning ignition on.
  5. BLUE LED will flash continuously, meaning Can-Bus programmed.
  6. Turn ignition off.
  7. Unplug everything
  8. Reprogram using the regular programming method.

 

 

 

answered Dec 2, 2013 by Robert T (297,620 points)
...