What is the modification to modify EVO-GM1 to EVO-GMv2?

Question

What is the modification required

Answer 1

The modification is done from the RED connector that plugs into the EVO. Do not cut any wires anywhere else.

 

1. Cut the yellow/red and light blue/black 2-3 inches from the red connector.
2. Join both yellow/red and light blue/black together from the non connector side (harness side); solder and tape connection.
3. Take the yellow/red coming from the connector side and connect it to a constant 12V source. You can tap into the red wire of the datalink connector for constant 12V.
4. Take the light blue/black coming from the connector side and connect it to the ignition wire. You should tap into the yellow wire of the EVOs 20-pin white connector.

Answer 2

You will have to cut lt.blue/black wire from the red plug on EVO, and send the connector side to the yellow wire on EVO 20 pin connector(Ignition). Then cut yellow/red wire from red connector and send connector side to red (12volts) on 4 pin data link connector. The other side of the cut wires (yellow/red and lt.blue/black) you will join together. You have now converted a v1 to a v2 harness. This combo will work as a remote starter provided you activate option 15 in the EVO-ALL options menu. You do not need a seperate remote starter. You can refer to our website for the diagram if you like.