Questions & Answers

2013 g37 install, no start

0 votes
2013 g37 automatic install, all wheel drive

bought the evo-nist1 for infinity with firmware 72

program sucessful, with blue light on programmer when press lock on oem key

no remote start after pressing lock x3

car will start with brake pedal and push button

any advice?

On my 2013 do i have to cut the loop? And how/where is that?

Have the flash link, hopeing i wouldnt have to open it, but will if i have to

all connections have been recked and tightened - exception : i used a t-tap for the ignition, hesitant to take it off

 

thanks for all the help in advance

 

andrew
posté Sept 26, 2016 dans la catégorie Infiniti par Andrew Mcintyre (130 points)

1 Réponse

0 votes

Hi,

 

There is no loop on an Evo-All, (that is only on the Evo-ONE),

The service number you provided is for an Key Override-All, we need the service number of the Evo unit.

 

exception : i used a t-tap for the ignition, hesitant to take it off

If you used the NIST-1 and an evo-all, there should not have been any need to connect to an Ignition wire, what exactly do you mean by this statement?

 

Thank you,

répondu Sept 26, 2016 par J M (64,060 points)
Service 001A06 591512

 

on the instructions. I believe it said i needed to connect the white/black wire to the brown wire on my ignition. Was this incorrect?
I have the key port, brake switch, and obd II connected.

then i took the black/white (a19) and connected it to the brown wire on the push to start wiring harness

Have a male and female 4 pin not connected to anything

let me know if any of that is incorrect
the white/black is to control the Start/Stop button.

the module starts the car like a human; it presses on the brake, then presses on the push button.

 

When remote starting, you should be seeing the RED LED turn on first along with all 3 brake lights.
Ok, i get a blue led light when i press the lock button. what does this mean?

When i press lock x3 i get nothing

 

also do my connections seem correct?
you need to turn on option D1 then test again
Sorry to bump an old thread, but...

I have the exact same issue on my most recent install.

I have everything hooked up correct (per the wiring diagram)

I am not seeing any RED lights illuminate and the system never initiates a start sequence.

Had a similar issue with my other car's install and it was a setting there.

Just to cover the bases. I have tried the following. (left all switches in the default position initially, confimed the firmware version. The device programs correctly. The blue light responds to RKE signal, the yellow light illuminated when the car is in the ON postion.

A settings - all active (disable hood later, no change)

B OFF

C1 ON

D1 ON

(all other D off)

D1.6 (ON and OFF, no change)

D6 on (default)

RF on (also tried OFF, no change)

H3 on (default position)

(I have another EVO ALL in my box that was tested to ensure the module integrity, with all default settings and it still does not function)

I have confirmed all connection throught NIST harness and BCM harn connection. PTS switch, parking lights, and A15 door pin are secure and have the correct signals going to the box. Brake switch signal exists on the red wire of RL2

 

Several hours in and I have tried almost every modification and I cannot get any activity out of this setup...a little help would be apprecaited, I only have so much hair remaining to pull out over this favor.
...