English

Questions & Answers

2016 Ram wont start service #001A06 506999

service #001A06 506999 firmware 74.24 evo all and thar-chr6 with astrostart remote evo programmed properly when remote starting evo red light turns on but doesnt crank or start ignition not turning on. evo is not getting ign signal from remote (diode installed as per diagram). when i supply evo with ign on yellow wire truck starts and runs. yellow wire is also connected to pink/green wire on truck. is this a diode issue? with diode installed properly the evo wont recieve ign signal from remote.

fermer avec la note: problem solved

posté Fev 23, 2016 dans la catégorie Ram par Douglas Buhs (310 points)
fermé Fev 23, 2016 par derek g

1 Réponse

Did you check the wire you connected to in the vehicle too see if it is a ignition wire?

répondu Fev 23, 2016 par derek g (340,410 points)

yes it is the pink/light green wire #6 pin in 10 way connector it is 12 volts key on

commenté Fev 23, 2016 par Douglas Buhs (310 points)

Do you have a flash link updater?

commenté Fev 23, 2016 par derek g (340,410 points)

yes the evo has been flashed to latest software and encryption done

commenté Fev 23, 2016 par Douglas Buhs (310 points)

try flashing it the module to 74.22 and re program the module start to finsh including dcryptor. Tell me what the led's on the modle do when remote starting.

commenté Fev 23, 2016 par derek g (340,410 points)

flashed to 74.22, reprogrammed and dcryptor. when remote is activated evo red light is on solid and then astro start shuts down after about 10 seconds

commenté Fev 23, 2016 par Douglas Buhs (310 points)

Have you tried the evo in stand alone?

commenté Fev 23, 2016 par derek g (340,410 points)

no if i remove or reverse diode remote starts properly evo is not getting ign signal from remote it is getting a start signal but the remote shuts off due to no rpm signal

commenté Fev 23, 2016 par Douglas Buhs (310 points)

Did you use a t-harness?

Try it in stand alone enable option C1 and D1...This will tell us if its a remote start problem or bypass issue.

commenté Fev 23, 2016 par derek g (340,410 points)

thar-chr6 t-harness does rap connection need to be made for stand alone

commenté Fev 23, 2016 par Douglas Buhs (310 points)

no not mandatory

commenté Fev 23, 2016 par derek g (340,410 points)

in stand alone truck remote starts

commenté Fev 23, 2016 par Douglas Buhs (310 points)

ok so know we know its an issue with your remote start!!

are you using data or wire 2 wire?

If using data what protocol is your remote starter/evo-all set too?

commenté Fev 23, 2016 par derek g (340,410 points)

i just flashed to 74.19 truck remote starts now with diode installed as per diagram may have a software isssue with 74.22-.24 Thanks for the help and info

commenté Fev 23, 2016 par Douglas Buhs (310 points)

...